![]() ![]() I also have 13" and 16" toms, but I used the DW pre-set settings for a 14" and 16". The 10" sounds good and the 12" sounds great. So, I spent some more time this afternoon and used the pre-set DW tunings and the kit sounds so much better with these settings. I did notice after the fact the button for Top Head was "high" so that is/was probably the issue. The suggested frequencies were just way too high. It is possible I did not do something correctly, although I did input info on heads, hoops, tom diameter and depth, etc. I created that kit on the phone and they came out really high pitched to the point of being tin cannish. I messed around with tuning the 10" and 12" toms last night on my Recording Custom kit. I have an iPhone 5, which is what I've tested the app with so far. For simple fine tuning or storing your entire catalog of drums into a database with easy recall, in addition to the tone generator and headphone feature, this app will likely become commonplace among drummers.Īs others pointed out, it is ios 6. Overall, this app is considerably more feature-rich than the Drum Tuner app. ![]() Set the throne so that it can freely rotate, that way each lug can get dialed in at the same height/distance to the iPhone mic every single time. Getting an iKlip and keeping the phone stationary should hopefully reduce these errors.Ī thought is to get an iKlip, mount it on a mic stand and then put an individual drum on a throne (with maybe a towel on it to muffle the bottom head) next to the mic stand. This may be why there are false/conflicting readings. One minor complaint: Without an iKlip, you are forced to ball-park the distance and angle from the phone to the lug (in addition to not having enough hands for the phone, a stick and a key). Being able to hear the exact tone you are tuning to, through headphones (I recommend outside noise reducing phones, but the app makers says earbuds are fine), while also hearing your lug taps, is incredibly useful. Once you have a sound dialed in with your settings, a head change down the road shouldn't be as time consuming since each drum and all three frequencies (fundamental, batter, reso) are already stored in the app's database.Īnother great feature is the tone generator and headphone bypass. My favorite, and what appears to be the most relevant, feature, though, is if your drums are already in tune, you can get the fundamental frequency pretty quickly (1-3 taps on the batter with the drum mounted normally) and then fine-tune your batter/reso from there (muffling the side you're not tuning). into the database (I ignored some of these, such as the type of head, as I couldn't find see some of these details are relevant to the tuning process) - it's significantly more time consuming. If you want to get the more in-depth route - adding in each drum, dimension, shell type, name, ply thickness, etc. Fine tuning by ear from here may be beneficial, which is what I tend to do with a Drum Dial anyway. I found that with a few trips around to each lug, it wasn't too difficult to get the lugs within +-1-3 Hz. That said, for fine-tuning each lug, the process is about as quick as using a Drum Dial. This has pretty much been my experience with Drum Dials and the Drum Tuner app - each tap gives a slightly different reading, and the best one can do is approximate. The main downside is the false readings, which required four-five taps sometimes to get an accurate measure in the app (see below for possible reason why). If you want to bypass all of the settings and just use the main frequency read-out to measure each of the lugs, the process is fairly quick. The drums were already in tune for the most part. I gave this app a trial run yesterday- tuned a snare, rack and floor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |